Now you can start cutting bits of carpet. I prefer to cut for the sides of the base first allowing overlap the underside 3' by 3' glue and staple in place with the staple gun. If some of the staples are visible the utilize the hammer to pound them in further. Use your carpet knife to remove carpet where the doors are then stable the carpet around the door. Next cover the most truly effective and trim around the 4 by 4 posts, and staple. Leave the posts bare for now. pillar tv mount

With the past 3' by 3' piece cut right out a 5 or 6 inch circle in the center employing a coping saw then attach it to the posts with glue and at the least 3 number 10 or 16 gauge nails. You will carpet the posts and top perch, (both sides please on the perch), and cut right out the carpet to open up the hole/door to the perch. Staple around both sides of the entranceway along with all edges. On the posts I like in order to complete attaching carpet with number 8 nails at the least on two sides but all is best. Nail about 4 nails 10 inches apart on all sides.

Lay the cat condo on it's side and attach the wheels, (optional), near each corner. First make use of a pencil and trace out where the screw holes are and darken that area with the pencil. Next use an exercise bit that's at the least half the diameter of the screw you uses and drill where the pencil marks are. Simplest way to install wheels, I like to accomplish just 2 opposite holes and then screw on the wheel to the base. Finish out another screw locations following the wheel is mounted.